SETTINGS - Analog Parameters Virtual Model Builder

Content by: Adrien Crouzet

Approved by: Christophe Veyrat

Last Update: 12/05/2022

You have printed your models, it is time to insert your analogs. You realized that they are too loose or too tight? No problem here is how you can fix this:

Open Material Management, then select the material you are using for your models, go to the Virtual Model Builder section and open the tab Analog Parameters and modify the Analog Holder Radial Offset value following this:

- Positive value: Increase the value to loosen

- Negative value: decrease the value to tighten 

Tips: In order to find your sweet spot, change the value little by little ( +/- 0.01)