CAD - How can I ajust the cement gap on a TiBase

Content by: Guillaume Ferrenbach
Approved by: Cecile Peyrot
Last Update: 01/13/2022

For scanned  TiBase case, the cement gap parameters are only available if you choose custom abutment.

The workflow is :

To enter the desired values you must right click on the crown, go to "Recompute":

Go to the "Prothesis Type", select "TiBase Abutment" and click "OK" 

After that you have an abutment, now you right click on this abutment and go to "Recompute" :

In "Coping Parameters" you can see the virtual spacing values :

Enter the desired values and click on "OK".

Now the values have been saved.

"Recompute" again and select a "Full Crown on Implant" in the "Prothesis Type".

Now you have the crown with the proper values :